Muir Storm VR1250 1000W 1100lb Low-Profile Windlass

A 1,000W 12V DC motor and a low-profile vertical gypsy define theMuir Storm VR1250. The windlass has a stated maximum pull of 1,100 lbs and a 275 lbs continuous working-load rating. Its mirror-polished marine-grade 316 stainless steel exterior forms the listed deck housing.

The gypsy accepts 1/4 in or 5/16 in chain with 1/2 in three-strand rope. A compact right-angle worm reduction layout transfers motor output, while the fall-safe mechanical lock and socket clutch provide the listed holding and release functions.

Which Boats This Windlass Fits

The Storm VR1250 windlass is recommended for cruising sailboats and center consoles from 26 to 38 ft. Its gypsy requires the selected 1/4 in or 5/16 in chain to match 1/2 in three-strand rope. Buyers should confirm both chain diameter and rope size before selecting anchor rode components.

The 1,100 lbs figure is the listed maximum pull rating. The 275 lbs working-load rating provides the separate continuous hauling value. Boat owners should use the continuous figure when assessing normal anchor retrieval requirements.

Care and Operating Notes

Rinse the housing, gypsy, chain, rope, mechanical lock, and socket clutch with fresh water after saltwater exposure. Remove salt, sand, mud, and debris from the rope-to-chain transition before operation. Inspect chain links, rope condition, clutch action, lock movement, visible fasteners, and electrical connections before departure. Follow the manufacturer manual for gearbox service, lubricant selection, disassembly, and approved replacement parts.

Warranty and Support

The Storm VR1250 carries a 3-year limited commercial and pleasure marine warranty. Coverage follows the manufacturer’s stated warranty terms and may be subject to exclusions, conditions, and registration requirements.

Before Ordering

Confirm that your anchor rode uses 1/4 in or 5/16 in chain with 1/2 in three-strand rope. You should compare your boat with the 26 to 38 ft application guide, allow for the 34.2 lbs unit mass, and confirm that the 12V system supports the listed 50A working-load draw with an 80A circuit breaker. Consult manufacturer installation documentation for deck thickness, mounting dimensions, and below-deck clearance.