Quick RRC H902 Radio Remote Control Hand Held Transmitter – 2 Button

TheQuick RRC H902is a two-button handheld radio remote transmitter for wireless anchor windlass and winch-system control. It uses a 434.420 MHz carrier frequency and has a stated open-marine-field range up to 164 ft. The ergonomic high-impact shockproof ABS plastic housing measures 115 mm high by 60 mm wide.

The handheld enclosure carries the listed IP67 watertight marine deck-protection rating. A snap-in wall-mounting cradle is included. The provided product data does not confirm a receiver, battery, wiring, control module, or compatibility with every windlass and winch system.

Care and Operating Notes

Rinse the handheld casing, buttons, and wall cradle with fresh water after saltwater exposure. Remove salt, sand, and debris from the button surfaces, enclosure seams, and cradle contact areas before use. Inspect the housing, buttons, wall cradle, and mounting hardware for damage or loose parts before operating connected equipment. Follow the manufacturer manual for battery service, pairing, maintenance, and approved replacement parts.

Warranty and Support

The RRC H902 carries a 2-year limited manufacturer warranty. The provided warranty term does not define coverage for labor, corrosion, connected equipment, shipping, receiver components, or batteries. These terms reflect manufacturer-stated coverage, and buyers should verify active warranty policies directly with the seller or manufacturer prior to purchase.

Before Ordering

Confirm that your installed receiver and anchor windlass or winch system support a two-button handheld transmitter using a 434.420 MHz carrier. You should verify the required pairing procedure, mounting-cradle location, and receiver interface before ordering. Treat the up-to-164-ft figure as the listed open-marine-field range rather than a guaranteed onboard range. The snap-in wall cradle is included, but the provided product data does not confirm a receiver, battery, antenna, wiring, or control module.