Lewmar V2G Vertical Windlass (Gypsy) – For Boats 30 – 40 Ft., Max Pull: 650 lbs.

TheLewmar V2Guses a 700W 12V DC motor in a low-profile vertical gypsy-only arrangement. The windlass has a stated maximum pull of 1,433 lbs and a 360 lbs continuous working-load rating. Precision-cast 316 stainless steel forms the body, while an AISI 316 shaft supports the drive assembly.

The gypsy accepts 5/16 in DIN 766 or ISO 4565 chain with 1/2 to 5/8 in three-strand rope. The Fast-Fit free-fall system includes an integrated manual override. The provided product data does not confirm an anchor, rode, switch, contactor, or circuit breaker as included.

Which Boats This Windlass Fits

The V2G vertical windlass is recommended for power and sailboats from 30 to 40 ft. Its gypsy requires 5/16 in DIN 766 or ISO 4565 chain paired with 1/2 to 5/8 in three-strand rope. the listed chain standard and rope diameter must match the gypsy configuration before ordering a rope-to-chain rode.

the listed maximum pull is 1,433 lbs. The 360 lbs working-load rating gives the separate continuous hauling value. The continuous figure provides the relevant reference for routine anchor retrieval assessment.

Care and Operating Notes

Rinse the exposed housing, gypsy, chain, and rope with fresh water after saltwater exposure. Remove salt, sand, mud, and debris from the chain links, rope transition, and Fast-Fit release area before operation. Inspect chain links, rope condition, manual override access, visible fasteners, and electrical connections before departure. Follow the manufacturer manual for lubricant selection, service intervals, disassembly, and approved replacement parts.

Warranty and Support

The V2G carries a 3-year limited manufacturer warranty. The provided warranty term does not define coverage for labor, corrosion, electrical accessories, shipping, or other components. These terms reflect manufacturer-stated coverage, and buyers should verify active warranty policies directly with the seller or manufacturer prior to purchase.

Before Ordering

Confirm that your anchor rode combines 5/16 in DIN 766 or ISO 4565 chain with 1/2 to 5/8 in three-strand rope. You should compare your boat with the 30 to 40 ft application guide, measure deck thickness against the 1.0 to 2.0 in range, and reserve room for the 133 mm above-deck height and 155 mm base diameter. Verify that your 12V system supports the listed 80A average draw and required 90A slow-blow breaker. Confirm controls, circuit-protection hardware, anchor, chain, and rope with the seller because the provided product data does not confirm them as included.