Lewmar VX1 GD Vertical Windlass with 8mm Gypsy & Drum, 500 Watt

A gypsy and warping drum sit above the vertical drive assembly of theLewmar VX1. The 500W 12V DC motor has a stated maximum pull of 882 lbs and a 220 lbs continuous working-load rating. Its stainless steel top cap and lightweight composite sub-deck structure form the listed housing arrangement for 8 mm DIN 766 or ISO 4565 chain.

The gypsy accepts 12 to 14 mm three-strand or 8-plait rope with the listed 8 mm chain standards. A manual friction cone clutch controls the free-fall release function. The provided product data does not confirm an anchor, rode, switch, contactor, or circuit breaker as included.

Which Boats This Windlass Fits

The VX1 gypsy and capstan windlass is recommended for small cruisers and sailboats from 20 to 30 ft. The gypsy requires 8 mm DIN 766 or ISO 4565 chain with 12 to 14 mm three-strand or 8-plait rope. Boat owners should match the named chain standard and rope size to the gypsy before ordering a replacement rode.

The 882 lbs maximum-pull figure describes the listed peak rating. The 220 lbs working-load rating identifies the separate continuous hauling load. Buyers should use the working-load figure when assessing regular retrieval demands.

Care and Operating Notes

Rinse the top cap, gypsy, warping drum, chain, and rope with fresh water after saltwater exposure. Clear salt, sand, mud, and debris from chain links, the rope-to-chain transition, and clutch area before operation. Inspect rope condition, chain links, clutch movement, visible fasteners, and electrical connections before departure. Follow the manufacturer manual for lubricant selection, service intervals, disassembly, and approved replacement parts.

Warranty and Support

The VX1 carries a 3-year limited manufacturer warranty. The provided warranty term does not define coverage for labor, corrosion, electrical accessories, shipping, or other components. These terms reflect manufacturer-stated coverage, and buyers should verify active warranty policies directly with the seller or manufacturer prior to purchase.

Before Ordering

Confirm that your anchor rode uses 8 mm DIN 766 or ISO 4565 chain with 12 to 14 mm three-strand or 8-plait rope. You should compare your boat with the 20 to 30 ft application guide, measure deck thickness against the 0.8 to 1.6 in range, and allow for the 185 mm height, 143 mm base diameter, and 24.2 lbs dry weight. Verify that your 12V system supports the listed 35A average draw and required 50A circuit breaker. Confirm controls, circuit protection hardware, anchor, chain, and rope with the seller because the provided product data does not confirm them as included.