Lofrans Project 500 Vertical Windlass, Low Profile, Chrome, 1/4″ HT – 500W – 12V

TheLofrans Project 500is a low-profile vertical gypsy-only windlass with a 500W 12V DC motor. The windlass has a stated maximum pull of 1,389 lbs and a 209 lbs continuous working-load rating. Its mirror-polished chrome-plated bronze housing and AISI 316 stainless steel shaft form the listed deck and drive assembly.

The gypsy accepts 1/4 in high-test or DIN 766 short-link chain. A manual friction brake clutch system controls the listed release and braking function. The provided product data does not confirm an anchor, chain, rope, controls, contactor, or circuit breaker as included.

Which Boats This Windlass Fits

The Project 500 vertical windlass is recommended for power and sailboats from 18 to 30 ft. Its gypsy supports 1/4 in high-test or DIN 766 short-link chain. Buyers should verify the exact chain type before ordering because The available product details do not list rope compatibility.

the listed maximum pull is 1,389 lbs. The 209 lbs working-load rating provides the separate continuous hauling value. The continuous figure should guide regular retrieval assessment, while maximum pull remains a peak rating.

Care and Operating Notes

Rinse the housing, gypsy, chain, and exposed shaft with fresh water after saltwater exposure. Remove salt, sand, mud, and debris from the chain links, friction-clutch area, and deck hardware before operation. Inspect the chain, clutch movement, visible fasteners, and electrical connections before departure. Follow the manufacturer manual for lubricant selection, service intervals, disassembly, and approved replacement parts.

Warranty and Support

The Project 500 carries a 3-year limited manufacturer warranty. The provided warranty term does not define coverage for labor, corrosion, electrical accessories, shipping, or other components. These terms reflect manufacturer-stated coverage, and buyers should verify active warranty policies directly with the seller or manufacturer prior to purchase.

Before Ordering

Confirm that your anchor rode uses 1/4 in high-test or DIN 766 short-link chain before ordering. You should compare your boat with the 18 to 30 ft application guide, measure deck thickness against the 0.8 to 1.2 in range, and reserve room for the 82 mm above-deck height and 130 mm base diameter. Verify that your boat uses a 12V system and can use the required 50A circuit breaker. Confirm controls, contactor, circuit protection, anchor, chain, rope, and mounting hardware with the seller because the provided product data does not confirm them as included.